Loading

3Watt stereo ampliifer

admin April 21, 2008 4 Comments

About the circuit.

Here is a small but effective mini stereo amplifier circuit based on the MAX 7910 IC.The circuit can deliver a 3W power to a 4 Ohm load .The main feature is that the circuit can be operated from a single power supply.All these makes the circuit ideal for a mini box amplifier.Since only 3W is handled the IC doe snot need a heat sink .In addition the IC MAX 7910 has a built in  thermal overload protection which makes it quite difficult to be destroyed.

Circuit diagram & Parts list .

3-watt-srereo-amplifer.JPG

Notes. 

  1. Use a well regulated and filtered 5V DC power supply to power the circuit.
  2. For hand held applications a 6V battery with a IN 4007 diode in direction and  series to the  positive terminal of the battery can be used.The diode drops 0 .7 volts to give the IC ,the rated 5V supply.This is an adjustment for additional safety.
  3. The circuit can be assembled on a good quality Vero board.
Comments
  • September 7, 2010

    3Watt stereo ampliifer…

    The circuit can deliver a 3W power to a 4 Ohm load .The main feature is that the circuit can be operated from a single power supply………..

  • khan
    February 25, 2011

    I like your amplifier diagram circuit for to channel
    3 watts but one things you did not measured the capacitors…like c2 0.1uf…how abut volt?

  • Gordon Jackson
    May 30, 2011

    What impresses me most is thatthe circuit can be perated from a single power supply. Wish you well on your promotional efforts.

  • Gordon Jackson
    May 30, 2011

    What impresses me most is that the circuit can be perated from a single power supply. Wish you well on your promotional efforts.

Leave a Reply

Your email address will not be published. Required fields are marked *